Home » Electrical, News » Getting the World off oil and running on electricty starts now.

Getting the World off oil and running on electricty starts now.

Since the early 1900s free unmetered energy was discovered and the technology behind this free unlimited and unmetered source of energy was made public by people like Nikola Tesla and Thomas Henry Moray. To demonstrate how this free unlimited energy source can be used by mankind Nikola Tesla powered an all steel frame and body 1931 Pierce-Arrow with electrical energy that was harnessed from thin air. Not a drop of gasoline or diesel fuel was used. In fact the internal combustion engine was completely removed. No bulky battery banks were used either. This vehicle was driven to speeds of 90 miles per hour with no fossil fuel and just a single 12 volt battery.

Just as Nikola Tesla did in 1931, Kincaid Energy Technology and Solutions will demonstrate that we don’t need a drop of gasoline or a single watt of metered public utility electric power to power our vehicles.   Tesla used a brand new Pierce-Arrow touring car at the automaker’s factory in Buffalo, New York.  Kincaid Energy Technology and Solutions will remove the gasoline combustion engine from a modern day mass produced gas combustion car, as well as all of its gas combustion engine parts – like the gas tank, gas lines, and the entire exhaust system.  In place of the gasoline combustion engine a newly designed drive-charge ™ electric motor will be installed.  This new electric motor design will eliminate the need to stop and recharge using metered public utility electrical power.  The motor will recharge the vehicle while it drives.

This new electric motor design will allow all electric cars to travel many times further than any existing electric car.  No expensive and bulky battery packs will be needed.  No metered charging stations would ever need to be built.  No longer would an electric vehicles’ driving range be limited to the limited energy stored in very expensive and bulky battery packs.  The drive-charge electric motor would give electric vehicles an unlimited driving range.  No CO2 emissions would ever be emitted.  Zero CO2 emissions would mean the end to gas combustion engine created smog.  Global warming would no longer be a concern.  Carbon emission related illnesses and diseases would disappear.

If you would like to accelerate getting the World off oil and running on clean, unmetered, free electricity you can make a donation today by using PayPal.  Click on the PayPal Donate button below to make a donation.

 

The ultimate goal of this project is to demonstrate, once again, the viability of Tesla’s discovery – powering a vehicle using free energy.  To honor Tesla and replicate his technological feat the successfully converted vehicle will be driven nonstop from Oshawa, Ontario – the automotive capital of Canada – to Buffalo, New York – where it all began – and back.  The trip covers 444 kilometers (275 miles) or 5 hours of driving without using a drop of petrol and without stopping to plug in and recharge.

You can help make history.  You can help get the World off oil and running on electricity now.

Short URL: http://frenergy.ca/news/?p=503

Posted by on Jun 15 2012. Filed under Electrical, News. You can follow any responses to this entry through the RSS 2.0. You can leave a response or trackback to this entry

1 Comment for “Getting the World off oil and running on electricty starts now.”

  1. As of November 22, 2012 a total of $70 has been donated towards this project.

You must be logged in to post a comment Login

Other News

H2O Fuel

H2O Fuels

Cold fission - the definition of fission is – splitting or breaking up into “parts”. Electrolysis of water is cold fission. It splits water (H2O) into Hydrogen gas (H2) and Oxygen (O). Hydrogen is a clean burning fuel. There are no environmental bi-products or side effects (zero carbon emissions, zero toxicity, zero tailings, zero watershed contamination, zero earthquake inducing fracking) associated with burning a hydrogen (H2) gas fuel. When we split the hydrogen (H2) from the water (H2O) we are left with Oxygen. Something we and every other living creature on Earth needs to live.

energy tip


Save money and instantly reduce your electrical consumption by 4500 watts.  Read how ...

Free unlimited EM Energy


Six feet above the ground (above head height) the air is charged with more than 200 volts positive of free energy.  This free energy is available day and night, 365 days a year and for millenniums.   That 200 volts + charged air is a source of free, unlimited, unmetered and carbon-free electrical energy.   The free energy is electromagnetic (EM) energy.  It can and has already been tapped into by World renowned scientists such as Nikola Tesla and Henry Moray.   Both tapped into this infinite supply of pure, zero emission electrical energy using a simple antenna. The Egyptian Pyramids were actually built as electrical power generating plants – not tombs. They were built to receive, store and transmit the free electromagnetic energy. The pyramid itself is a very large capacitor – stores electrical energy. They were made of granite (the dielectric or insulator) and sandstone (the quartz crystal electrical conductor) with a capstone (the antenna) made of granite, basalt, or any other very hard stone which was plated with Electrum – alloy of gold and silver, with trace amounts of copper and other electricity conducting metals.

Hydrogen Fuel from Water



FuelReducer H2O Fuel Cell video demonstrates just how easy it is to fuel the World with hydrogen fuel from water instead of oil or gas. Hydrogen (H2) fuel cells are being developed to convert any gasoline fueled vehicle into a hydrogen fueled vehicle that has zero emissions.  Instead of gasoline your vehicle can be fueled with hydrogen that is split from water using a radio wave frequency.  You can use water collected from a stream, pond, lake, river, ocean, ditch, swimming pool, household faucet or rainfall to fuel your vehicle, heat your home, cook your food, and fuel your electrical power generators.     In the video above just 4.5 volts was used to split water into a hydrogen and oxygen gas. Some of the frequencies (F) in hz and Duty Cycle (D) used - F640 D60, F800, D80, F1200. 6 volts would produce considerably more hydrogen gas fuel and 12 volts (just 10% or 1/10 the electrical power needed to power every toxic fluorescent light which requires 120 volts to operate) would produce more than enough hydrogen fuel to power a gas combustion engine like a portable electrical power generator. Another video of a working hydrogen fuel cell

FEATURED VIDEOS

Electric Cars Built 1st

Thomas Edison in his 1914 electric car. The electric car has been around longer than the gasoline car. They were being manufactured and sold before the advent of the gasoline powered cars .

Gas to Electric



Video shows you just how easy it is to convert a gasoline powered car into an all electric powered car. If a home mechanic can easily do it the automakers most certainly can too.

Free renewable biofuel



Uganda Africa construction video on how to make your own backyard biogas plant.  Daily gas production capacity of the above constructed digester is 2.6 cubic meters (time stamp 3:23).  That is equivalent to 2600 liters or 16.4  barrels of oil or 687 US liquid gallons.  For comparison an empty 20 lb barbecue propane tank will hold about 4.7 gallons of propane. Biogas can be used to heat your home, cook your food and power gas electric generators.  In the US and Canada you can use your existing prefab concrete or plastic septic tanks and produce your own biogas to fuel your home.  Bury a sealed plastic barrel or tank next to the septic tank and run a plastic tube from the top of your septic tank to the buried sealed plastic barrel or tank.  Then add a propane gas valve and fitting, like the ones from a barbecue, to the top of the sealed buried barrel or tank and you have your very own natural gas supply.

Free natural gas supply


Generate and collect free biogas fuel to fuel your home heating gas furnace, gas fireplace, gas generator, or other gas fueled appliances using your existing septic tank.  The free biogas fuel is generated 24/7 and 365 days a year.  A biogas collector sits on top of your existing septic tank.  Use any large "airtight" plastic or metal container (even a plastic fuel tank) as your biogas collector.  Join the septic tank to the collector using mass produced flexible plumbing tubing.  Run a pipe from the top of the collector to just above ground height. Attach a gas regulator value (like the ones used for barbecues) to the top of pipe to control the gas flow. Fill in with dirt and let mother nature generate a lifetime supply of free ecofriendly biofuel. 

Free Unmetered energy


Above displayed design and concept by © Paul W Kincaid - Generate unmetered AC and DC power simultaneously by coupling the shaft of a farm duty electric motor to the rotor shaft of a generator motor. Add a serpentine pulley to the joined shafts and connect with a belt to an attached alternator and recharge a 12 volt car battery. Running the electric motor power generating system off of a DC 12 volt car battery will recharge the battery as it generates free unmetered AC electrical power. If you use an AC electric motor that runs off AC current (from a wall outlet) connect a mass produced, store bought, power inverter to the alternator's battery output terminal and convert that output voltage (typically 13.8-14.2 volts) into free unmetered 120 volts. Add a switch to cut off the metered power and thereon power the AC motor using only the inverter power. Self Sustaining perpetual Electricity Generating

Need more power than what 1 generator can provide? Simply add another generator to the system using the serpentine belt. Gasoline combustion engines makes use of a serpentine belt to power your auto's accessories as the crankshaft turns. The same belt turns your alternator, power steering pump, air conditioning, water pump and so on. So you can use more than one electric power generator on your electric motor power generating system.


Click on the image above to download a .pdf instruction file on how to make your own FuelReducer mpg+ (developed and marketed by frenergy.ca's editor Paul W Kincaid) using mass produced, store bought, parts. You can use the instruction pdf file to build your own FuelReducer mpg+ and add an average of 5 mpg (potentially adding 100 miles per 20 gallon gas tank) to your vehicle's fuel efficiency plus (+) lower carbon emissions.  This simple device added 6 mpg to the fuel efficiency of a 1970 RS/Z28 Camaro powered by a 350 492 HP engine and the vehicle's owner reported that it ran the quarter mile in 11.92 seconds with a DIY FuelReducer mpg+ installed.

FAIR USE NOTICE:

The above videos may contain copyrighted material. Such material is made available for educational purposes only. This constitutes a 'fair use' of any such copyrighted material as provided for in Title 17 U.S.C. section 106A-117 of the U.S. Copyright Law.

© 2017 frenergy.ca – Free Renewable Energy. All Rights Reserved. Log in - Designed by Gabfire Themes